ROCKCOTE SYSTEM CHART – HEBEL POWER PANEL & BLOCKS

SUBSTRATE	SYSTEM	COMMON NAME	SURFACE PREP.	1ST COAT	FINISH	2ND COAT	FINISH	3RD COAT	FINISH	4TH COAT	G/TEE
A.C.C. Hebel Power Panel	Skimcote V6, PM100 Render or Q Render	Sponged Render	Patch blow holes, sand & tape joints**	Prime	Roller or spray	Skimcote V6, PM100 Render or Q Render	Float & sponge	Armour	Roller or Airless sprayed	Armour	10
Hebel Power Panel	2, 2.5 or 3mm Trowel-On	Scratch coat	Patch blow holes, sand & tape joints**	Prime	Roller or spray	2, 2.5 or 3mm Trowel-On	Travertine or swirl	Armour	Roller or Airless sprayed	Armour	10
Hebel Power Panel	Polymer Render Ultrafine Flat	Ultrafine Flat	Patch blow holes	Prime	Roller or spray	Polymer Render (Min DFT 1000 microns)	Float	Polymer Render (Min DFT 1000 microns)	Float	Ultrafine Flat (2 coats) Roller	10
Hebel Power Panel	Polymer Render Torino	Torino	Patch blow holes.	Prime	Roller or spray	Polymer Render (Min DFT 1000 microns)	Float	Polymer Render (Min DFT 1000 microns)	Float	Torino (2 coats) Brush	10
NOTE: Prior to the application of any acrylic coat finer than 2mm, the Power Panel will require a base of Rockcote Skimcote V6, PM100 Render, Q Render or Polymer Render to create an even surface. **Meshing of joints is only required if panels are not already joined with adhesive.
Hebel Block	Skimcote V6, PM100 Render or Q Render	Sponged Render	Patch repairs mesh 45° Prime	Skimcote V6, PM100 Render or Q Render	Trowel, float, sponge	Armour	Roller or Airless sprayed	Armour	Roller or Airless sprayed	Armour	7.5
Hebel Block	Skimcote V6, PM100 Render or Q Render 2, 2.5 or 3mm Trowel-On	Scratch coat	Patch repairs mesh 45° Prime	Skimcote V6, PM100 Render or Q Render	Float finish	2, 2.5 or 3mm Trowel-On	Travertine or swirl	Armour	Roller or Airless Sprayed	Armour	7.5
NOTE: It is important that the Hebel Blocks have a coat of ACRYBOND or MASONRY PRIMER, diluted 50/50 with water, sprayed or brushed over the entire surface prior to the application of Skimcote V6, PM100 Render or Q Render. After base of Skimcote V6, PM100 Render or Q Render has been applied, the decorative finishes referred to in Bricks & Blocks Section may be applied.
IMPORTANT NOTE: USE THIS SYSTEM IN CONJUNCTION WITH THE TECHNICAL SPECIFICATION SHEET RELATED TO THE PRODUCTS MENTIONED. *** Warranty is valid only if product is applied by a skilled and experienced applicator and strictly in accordance with film-build and other specifications. ***