Rockcote Rollafine

Rockcote Rollafine provides a dense, high-build, fine stipple finish for the protection and decoration of masonry surfaces in interior or exterior sheltered situations. It is particularly suitable for covering substrate imperfections with minimum preparation. For a coarser, “grittier” finish, Rockcote Rollafine Grit may be preferred.

COMPOSITION

Rockcote Rollafine is formulated utilising a water based acrylic polymer binder, titanium dioxide pigment and quality mineral extenders and a powerful fungicide.

PERFORMANCE & PROPERTIES

Rockcote Rollafine is particularly suitable for the coating of soffits and balcony ceilings and can be continued up the face of the soffit or slab. In exposed positions, the application of Rockcote Armour over the Rollafine is recommended.

Weather Resistance

Rollafine provides a tough, flexible, water repellent barrier for all masonry surfaces while remaining vapour permeable, thus allowing the wall to “breathe”.

Flexibility

Rollafine has an ability to accommodate normal expansion & contraction of the substrate.

High Impact Resistance

Rollafine provides a high impact resistant finish & excellent scrubability.

Colour Range

Rollafine is available in natural white or may be tinted to a number of pastel tones on request.

APPLICATION

Surface Preparation

All surfaces to be coated should be clean, dry and free from dust or form release agents. Any deep surface imperfections should be filled using Rockcote Smooth Patch prior to the application of one coat of Rockcote Hi Opacity Primer.

APPLICATION Continued…

• The texture is applied to the wall using a specially perforated texture roller and rolled out to achieve an even stipple finish.
• Other textures may be obtained through variations in application technique and tools.
• The application of Rockcote Finecote is a specialist procedure & should only be carried out by a skilled and experienced applicator and in accordance with our technical specifications.

COVERAGE

Rockcote Rollafine, when applied by roller, will cover approximately 15 square metres per 15 litre drum.

PACKAGING

Rollafine is supplied in 15 litre heavy duty plastic pails. Smaller sizes are available on request.

STORAGE, SAFETY & HANDLING

Refer to Rockcote’s MSDS for Rollafine

• Pails should not be stacked more than two high during transportation and should be stored out of direct sunlight and above 4°C.
• When working with Rockcote Rollafine, observe the usual precautions for handling cement & water acrylic based products
• Avoid inhalation of the powder or vapour, prolonged skin contact and particularly eye contact.
• If contact occurs, flush thoroughly with clean water.
• In the case of Rollafine, if ingestion occurs, drink at least 2 glasses of water and consult a doctor.
• Wear protective clothing to minimise skin contact and wear goggles where splatter is likely.
• Where spills occur, soak up liquid spillage with sand/sawdust and dispose of in a sensible manner.
• Clean up equipment and area with water. Do not permit run-off to sewer, storm water or open bodies of water.

Indemnity

Rockcote Enterprises Pty Ltd will not accept responsibility for any misuse of this product if not applied by a skilled and experienced applicator and in accordance with our technical specifications. Due to our policy of continuing product improvement Rockcote Enterprises Pty Ltd reserves the right to change these specifications without further notice.

Revised June 2005